Tox Fasteners was founded in Germany in 1947 to design & manufacture fasteners for the global building industry. Tox focuses on unique & innovative fastening solutions for all substrates like brick, block, concrete & plasterboard, helping tradesmen & DIYers save time & money.
Multi-Purpose Anchors - Deco & Tri
- Use in almost any substrate
- Low-medium load ratings for all substrates
- UV stable for indoor or outdoor use
- Metric diameter for easy pre-drilling
- M5, 6, 8, 10 & 12 diameters available
Utility Anchors
- Used for water, gas, electricity lines in commercial buildings for fire rated anchors
- Ideal for all masonry substrates
- Pre-drill hole, hammer in anchor
- Use any coarse thread screw to anchor brackets to anchor
- M6, M8 & M10 diameters available
Hebel Anchors - Y-Tox
- Specialty anchor for Hebel (AAC)
- Medium duty load ratings 25-40kg per anchor
- Unique triangular shape to evenly disperse load in aerated concrete
- M10, M12, M14 diameters available
- Use any coarse thread screw to fasten brackets or battens
MSL Masonry Anchors
- Specialty anchor for high load capacity in concrete, brick, besser block & hebel
- Easy to install, complete in less than 2 minutes:
- pre-drill 12mm hole
- hammer in anchor (up to washer)
- tighten with spanner, wrench - 60, 80, 100, 120mm lengths available
- High load capacity without the need to wait for chemical to set
Polystyrene Anchors - Thermo ISOL
- Specialty anchor for fixing small brackets, downpipes or light fittings to rendered polystyrene (green board) insulation panels
- Use 10g (M5) screw for fixings
- Installation instructions:
- remove small layer of render with 19mm spade bit for flush finish
- insert anchor with Torx40 driver bit
- attach bracket with 10g (M5 screw)
Available at NHS NOW!